Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Windows 10 1803 Hyper-V IPXE initialising devices
2018-08-10, 08:50
Post: #1
Windows 10 1803 Hyper-V IPXE initialising devices
Hi,

I have a problem with using IPXE on a Hyper-V Gen1 VM it stucks at IPXE initialising devices
[Image: 1803.jpg]
I use the iso from http://boot.ipxe.org/ipxe.iso
I read this thread http://forum.ipxe.org/showthread.php?tid=10998 they say that it works with 1803 but it is not working for me with the most recent updates. Build 17134.191

Best Regards
Find all posts by this user
Quote this message in a reply
2018-08-15, 12:21
Post: #2
RE: Windows 10 1803 Hyper-V IPXE initialising devices
If this is the same issue, then post in that existing thread.
You have one quite major difference and that is that you are using ipxe.iso while in http://forum.ipxe.org/showthread.php?tid=10998 undionly.kpxe is mainly used (it is loaded by chainloading over original PXE stack)

You might want to test with both clean 1709 installation of windows and clean 1803 - without any additional updates and see if that gives any difference in behavior.
Wouldn't surprise me if this was fixed in 1803 but some later update then caused issues again.

Use GitHub Discussions
VRAM bin
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)