iPXE discussion forum / iPXE user forums / General v / Sanboot Win7/8/10 after cloning disk on same Hardware

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sanboot Win7/8/10 after cloning disk on same Hardware
2019-08-11, 18:13 (This post was last modified: 2019-08-11 18:17 by misty.)
Post: #7
misty Offline
iPXE User
**
 		Posts: 12
Joined: 2017-Feb
Reputation: 0
RE: Sanboot Win7/8/10
@albrecht
I haven't got any SANBoot systems available at the moment to check, however I recall when installing Windows 8.*\10 to an iSCSI target that the NIC start value is NOT set to 0 - the system still boots fine.

If cloning an existing system, have you tried unbinding the Lightweight Filter (LWF)? See http://mistyprojects.co.uk/documents/Tin...wfplwf.htm

misty
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Sanboot Win7/8/10 - NiKiZe - 2019-07-19, 17:18
RE: Sanboot Win7/8/10 - albrecht - 2019-07-21, 20:01
RE: Sanboot Win7/8/10 - albrecht - 2019-07-22, 13:56
RE: Sanboot Win7/8/10 - NiKiZe - 2019-07-22, 17:20
RE: Sanboot Win7/8/10 - albrecht - 2019-07-23, 13:09
RE: Sanboot Win7/8/10 - misty - 2019-08-11 18:13
RE: Sanboot Win7/8/10 - albrecht - 2019-08-16, 10:48
RE: Sanboot Win7/8/10 - Andromeda_x - 2019-09-14, 00:10
RE: Sanboot Win7/8/10 - albrecht - 2019-09-17, 12:16
RE: Sanboot Win7/8/10 - NiKiZe - 2019-09-18, 02:02
RE: Sanboot Win7/8/10 - albrecht - 2019-09-19, 09:17



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication