iPXE discussion forum / iPXE user forums / General v / poweroff command not working after memtest

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
poweroff command not working after memtest
2018-04-27, 07:57
Post: #4
rexqian Offline
iPXE User
**
 		Posts: 4
Joined: 2018-Apr
Reputation: 0
RE: poweroff command not working after memtest
Hi everybody

About "chain memtest.0 onepass onefail && set memtest GOOD || set memtest BAD " ,
means, memtest.0 run 1 round and stop,

but how to make memtest.0 run 4 rounds?

I've tried:
"chain memtest.0 4pass onefail && set memtest GOOD || set memtest BAD "
"chain memtest.0 fourpass onefail && set memtest GOOD || set memtest BAD "
but no luck,
any suggestion is appreciated.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: poweroff command not working after memtest - rexqian - 2018-04-27 07:57



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication