Threaded Mode | Linear Mode

***NiKiZe*** · (This post was last modified: 2018-12-29 12:53 by NiKiZe.)

~~There is no native support for X710 in ipxe yet~~,
it have however been recently requested http://lists.ipxe.org/pipermail/ipxe-dev...05173.html
One request for native support was the speed issue.

You could test snponly.efi to force it to use the firmware NII/SNP mode but that is essentially what ipxe.efi falls back to when no native drivers are found. So checking for offical firmware/ROM upgrade might be worth a try.

The winpe hang can have many causes, I would check that the same wim works on another machine, and also that it works on this machine without the X710 NIC. Most of the time I have had issues with boot hangs due to Mass storage device drivers, rather then nic drivers or hardware. (I'm assuming you are using wimboot)

For reference, a different thread about X7xxx: http://forum.ipxe.org/showthread.php?tid=11170