Q: undionly.kpxe and sanhook to iSCSI target

[Andromeda_x]

Hello,

ok, it seems that the problem is resolved and Windows 7 was successfully installed in combination of

PXE->udnionly.kpxe->iSCSI->0x80->Windows 7 install -> Windows 7 boot

So far it was found that Windows 7 runs reliably on following hardware

MB: P5GCMX/1333
CPU: E8500
RAM: 2GB

NOTE 1: Stock Windows 7 installation without any alternation of installation media with assistance of wimboot
NOTE 2: Network utilization is between 5%-10% immediately after boot and latter goes to 85%-95% on 100Mbit network

I did an attempt to install:
Windows 10 -- installation gave a warning that it can not finish after "updates" step
Windows 8.1 -- installation rebooted the computer and at following boot gave error (0xc00021a)

NOTE 3: Windows 8.1 -- an attempt to boot without driver signature and safe boot both failed

Andromeda X