boot and install windows server

[bluedark]

Hi all,
My ipxe system works wonderfully except one point : the boot on a windows server 2019 works well but before the installation, it tells me that it misses the media driver.
When I boot a hyper-v virtual machine in ipxe on the same windows server 2019 but having added the iso of the dvd, it works well.
The question is: how to boot the vm in ipxe and be able to install windows server 2019 without being able to add the iso of the dvd (if I am remote and that I can't add it in the vm)?
Thank you !

---

for info (maybe important), my machines are in uefi

[bluedark]

no one to help me?
Thanks!

[bluedark]

UP
thanks !

[d4rk3]

You need to find which driver(s) you need to make it work. Then add them to your boot.wim that you are already using for booting WinPE.

[bluedark]

Hello
thank you for the reply.
I added the drivers to boot.wim, but I still can't see my hard drives.
I tried on 3 different computers ...
and even trying to load them manually, it doesn't work ...
How is it that it works well with a dvd or a usb stick, but not in pxe?
Thank you in advance!

[bluedark]

I tested with windows 10 and windows 7, same problem ...
With a DVD, when I load the driver it works, so I have the right drivers.
In my config, I launch the bcd file, then boot.sdi, then boot.wim.
Can you help me?
Thanks

[rollercoaster]

I presume you're wanting to install into an iscsi target. You need to install Windows 10 from WinPE (with iscsi stuff built-in).

[d4rk3]

I haven't played with Hyper-V in a while...

However, and this may or may not help, but in ESXi I always have to use IDE mode for the hard drive to be visible to the WinPE installer. Give it a shot in Hyper-V.

[sonwilliamson5]

I haven't played with Hyper-V in a while...

However, and this may or may not help, but in ESXi I always have to use IDE mode for the hard drive to be visible to the WinPE installer. Give it a shot in Hyper-V.
https://korean-drama-list.com/