iPXE discussion forum

iPXE discussion forum > iPXE user forums > General > Windows 10 1803 Hyper-V IPXE initialising devices
Full Version: Windows 10 1803 Hyper-V IPXE initialising devices
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

marcohald

2018-08-10, 08:50
Hi,

I have a problem with using IPXE on a Hyper-V Gen1 VM it stucks at IPXE initialising devices
[Image: 1803.jpg]
I use the iso from http://boot.ipxe.org/ipxe.iso
I read this thread http://forum.ipxe.org/showthread.php?tid=10998 they say that it works with 1803 but it is not working for me with the most recent updates. Build 17134.191

Best Regards

NiKiZe

2018-08-15, 12:21
If this is the same issue, then post in that existing thread.
You have one quite major difference and that is that you are using ipxe.iso while in http://forum.ipxe.org/showthread.php?tid=10998 undionly.kpxe is mainly used (it is loaded by chainloading over original PXE stack)

You might want to test with both clean 1709 installation of windows and clean 1803 - without any additional updates and see if that gives any difference in behavior.
Wouldn't surprise me if this was fixed in 1803 but some later update then caused issues again.
iPXE discussion forum > iPXE user forums > General > Windows 10 1803 Hyper-V IPXE initialising devices
Reference URL's