2013-11-25, 01:14
Hello,
I have a problem with the installation of Windows 7 on the iscsi-target.
As a server I use Debian is unix. Set up isc-dhcp-server, iscsitarget and tftp-server. All settings are made ??as in the examples.
When downloading via PXE see this:
DHCP (net XX:XX:XX:XX:XX) ... ok
Registered as BIOS drive 0x80
Booting from BIOS drive 0x80
Boot falied
Preserving connection to SAN DISK
Could not boot from iscsi:10.222.x.x::::xxxx Operation cancelled 0xb08080a0
The computer should boot from the next device (Like stated in the BIOS, let CD-ROM), but instead I see the message "PRESS A KEY TO REBOOT".
Why is this happening?
I tried to download via gPXE, the situation is the same.
Just tried to enter directly into the command line iPXE:
dhcp net0
set keep-san 1
sanboot iscsi:10.222.X.X:iqn.2013-11.loc.domain.storage:iscsiboot
exit
Result "PRESS A KEY TO REBOOT"
I made it like this: http://www.heath-bar.com/blog/?p=326
I have a problem with the installation of Windows 7 on the iscsi-target.
As a server I use Debian is unix. Set up isc-dhcp-server, iscsitarget and tftp-server. All settings are made ??as in the examples.
When downloading via PXE see this:
DHCP (net XX:XX:XX:XX:XX) ... ok
Registered as BIOS drive 0x80
Booting from BIOS drive 0x80
Boot falied
Preserving connection to SAN DISK
Could not boot from iscsi:10.222.x.x::::xxxx Operation cancelled 0xb08080a0
The computer should boot from the next device (Like stated in the BIOS, let CD-ROM), but instead I see the message "PRESS A KEY TO REBOOT".
Why is this happening?
I tried to download via gPXE, the situation is the same.
Just tried to enter directly into the command line iPXE:
dhcp net0
set keep-san 1
sanboot iscsi:10.222.X.X:iqn.2013-11.loc.domain.storage:iscsiboot
exit
Result "PRESS A KEY TO REBOOT"
I made it like this: http://www.heath-bar.com/blog/?p=326