Windows 10 1803 Hyper-V IPXE initialising devices - Printable Version +- iPXE discussion forum (https://forum.ipxe.org) +-- Forum: iPXE user forums (/forumdisplay.php?fid=1) +--- Forum: General (/forumdisplay.php?fid=2) +--- Thread: Windows 10 1803 Hyper-V IPXE initialising devices (/showthread.php?tid=12806)

Windows 10 1803 Hyper-V IPXE initialising devices - marcohald - 2018-08-10 08:50 Hi, I have a problem with using IPXE on a Hyper-V Gen1 VM it stucks at IPXE initialising devices I use the iso from http://boot.ipxe.org/ipxe.iso I read this thread http://forum.ipxe.org/showthread.php?tid=10998 they say that it works with 1803 but it is not working for me with the most recent updates. Build 17134.191 Best Regards RE: Windows 10 1803 Hyper-V IPXE initialising devices - NiKiZe - 2018-08-15 12:21 If this is the same issue, then post in that existing thread. You have one quite major difference and that is that you are using ipxe.iso while in http://forum.ipxe.org/showthread.php?tid=10998 undionly.kpxe is mainly used (it is loaded by chainloading over original PXE stack) You might want to test with both clean 1709 installation of windows and clean 1803 - without any additional updates and see if that gives any difference in behavior. Wouldn't surprise me if this was fixed in 1803 but some later update then caused issues again.