How to boot with PXE using USB 3.0 to Gigabit Network Adapter

How to boot with PXE using USB 3.0 to Gigabit Network Adapter - Printable Version

+- iPXE discussion forum (https://forum.ipxe.org)
+-- Forum: iPXE user forums (/forumdisplay.php?fid=1)
+--- Forum: General (/forumdisplay.php?fid=2)
+--- Thread: How to boot with PXE using USB 3.0 to Gigabit Network Adapter (/showthread.php?tid=21811)

How to boot with PXE using USB 3.0 to Gigabit Network Adapter - cheche - 2020-04-22 03:07

Hi,

I would like to share some notes that allow me to use an USB to Network Adapter to boot using PXE. I have a TPLINK UE300 v3 adapter (https://www.tp-link.com/en/home-networking/computer-accessory/ue300/) with a RLT8153 chip https://www.realtek.com/en/products/communications-network-ics/item/rtl8153

I would like to use it to boot PXE on a lenovo laptop without Ethernet port. If you use Debian, make sure that you have build-essential and git.

Code:

apt install git build-essential

Use git to clone the ipxe repository:

Code:

git clone https://github.com/ipxe/ipxe

build the CDC-ECM USB Ethernet driver in an usb format.

Code:

cd ipxe/src; make bin/ecm.usb

Plug a usb memory (you will lose all your contents within). This example uses /dev/sdc

Code:

dd if=bin/ecm.usb of=/dev/sdc

Now, on your device, plug the usb memory, the network adapter, and make sure that you boot up from the usb memory. it should be enough to boot up using PXE.

Other devices that may work with this driver:

Dell USB-C Network Adapter 470-ABND
Lenovo USB 3.0 Ethernet 4X90E51405
Microsoft 1663