Error when attempting to set dhcp option variable

[ebruno]

I rebuilt spnonly.efi and added the following script to it as an embedded script (see below)

#!ipxe
set ${ifname}.dhcp/user-class macpro-ESXiInstallRequest
clear ip4
dhcp
echo Chaining to http://${next-server}/provision_system?MAC_ADDRESS=mac=${${ifname}/mac}
chain http://${next-server}/provision_system?MAC_ADDRESS=mac=${${ifname}/mac}

No problems with the above script.

The chain command contacts the a web server.
The web server for testing generates the following script:

#!ipxe
set ${ifname}.dhcp/user-class ESXiInstallRequest
echo This file was loaded from a web server.
echo Initate a ${${ifname}.dhcp/user-class}
clear ipv4
dhcp
ifstat ${ifname}
route
echo Chaining to file ${${ifname}.dhcp/filename} on ${next-server} in 20 seconds
sleep 20
chain ${${ifname}.dhcp/filename}


The set ${ifname}.dhcp/user-class ESXiInstallRequest. command fails with the following message:

Could not store "user-classs: No space left on device (http://ipxe.org/3402608b)

Which points me here:

Error: No space left on device
(Error code 340260)

Possible sources
This error originated from one of the following locations within the iPXE source code:

net/dhcpopts.c (line 185)
net/dhcpopts.c (line 214)
net/dhcpopts.c (line 239)

When basically tell me is not enough memory space available to the image.

So two questions:
1) The question is why is there not enough space?
2) How do i allocate/reserve space at build time, run time or install time?
3) Am I missing a step or command to initialize the script coming from the web server?

I tried building with the MEMMAP_SETTINGS defined but got a build error.
I was able to enable the CPUID_SETTINGS and building.

Thanks in advance.

[NiKiZe]

First i must ask what is ${ifname} and why are you not using netX instead?

Have you tried clearing the user-class before setting it?
But maybe you should check if it already is set and if so skip the extra dhcp step anyway?
Right now I don't have the time to dig much more, but will try to tomorrow if I remember.

If memory serves me right MEMMAP_SETTINGS is not an option relevant to EFI builds, only pcbios.

[ebruno]

(2018-05-26 22:48)NiKiZe Wrote:  First i must ask what is ${ifname} and why are you not using netX instead?

Have you tried clearing the user-class before setting it?
But maybe you should check if it already is set and if so skip the extra dhcp step anyway?
Right now I don't have the time to dig much more, but will try to tomorrow if I remember.

If memory serves me right MEMMAP_SETTINGS is not an option relevant to EFI builds, only pcbios.

I was just following examples, ifname seems to be the active interface. i have only one NIC connected for my testing. The user-class variable is not set in the packet received by the client. The dhcp server is not sending it. I can add a test to see if is set but in that case I would want to change it regardless.

Can variables only be set once?
If so is this true when chaining to a new file that is not a new load, but just a and additional script?

I also got an error try to set the variable using the config util and it was displayed as "unassigned".

Should I set all variables with "dummy values" with the first ipse script that is embedded to reserve space? Then set and clear the variables/options as appropriate before issuing the dhcp request?

Thanks for the point on MEMMAP_SETTINGS.