WinPE Bad Magic, right names

[BirtyBassett]

My apologies for bumping an old thread but I have the same problem as OP. I am using the boot.ipxe, boot.ipxe.cfg & menu.ipxe scripts from this page.

Below is a section from the menu.ipxe where I've added in an entry for dart in between the two macrium entries. It doesn't seem to matter whether I use imgstat or not.

Quote::macrium-winpe
echo Booting Macrium Reflect ${macrium-version} (WinPE 4.0 ${arch}) for ${initiator-iqn}
set base-url macrium-${macrium-version}/macrium-${macrium-version}-rescue-winpe-4.0-${arch}
kernel wimboot
initrd ${base-url}/bootmgr bootmgr
initrd ${base-url}/Boot/BCD BCD
initrd ${base-url}/Boot/boot.sdi boot.sdi
initrd ${base-url}/sources/boot.wim boot.wim
boot || goto failed
goto start

:dart
set base-url dart
kernel wimboot
initrd ${base-url}/bootmgr bootmgr
initrd ${base-url}/boot/bcd
initrd ${base-url}/boot/boot.sdi boot.sdi
initrd ${base-url}/sources/boot.wim boot.wim
imgstat
boot || goto failed
goto start

:macrium-linux
echo Booting Macrium Reflect ${macrium-version} (Linux ${arch}) for ${initiator-iqn}
set base-url macrium-${macrium-version}/macrium-${macrium-version}-rescue-linux
kernel ${base-url}/vmlinuz
initrd ${base-url}/initramfs.xz
imgargs vmlinuz vga=0x317
boot || goto failed
goto start

This is the error I receive:



Any ideas?