WinPE x64 UEFI boot error 0x7f048283

[icabraja]

(2016-09-23 23:03)NiKiZe Wrote:  your winpe.efi returns and won't boot. (remember in efi mode only efi binaries can run, not legacy NBP files, so you need special handling of ${platform} or similar to detect and handle which file to download and run)

The recommended way to boot winpe from ipxe is using wimboot which is a NBP and efi combo file so very little, if any, special handling is needed.

also you might want to test a original build from http://boot.ipxe.org/ipxe.efi just in case rom-o-matic is the cause.

Hello again.

I have tried both ipxe.efi from the site and the one that I compiled myself, the error message is the same. And yes, I am using wimboot. In both BIOS and UEFI environment i get my menu presented to me. In BIOS environment it will boot WinPE x86 and x64 menu entries just fine, but in UEFI environment it wont boot the WinPE x64 UEFI menu entry and I get the above error message. Can You take a look at my menu.ipxe, am I calling the right files?

Thank You and best regards,
Ivan