iPXE boot Ubuntu 18.04 LUN
|
2019-03-13, 04:45
Post: #1
|
|||
|
|||
iPXE boot Ubuntu 18.04 LUN
Hi Guys,
iPXE noob starting out and I’m trying to use iPXE to boot an iSCSI LUN which contains an installed Ubuntu 18.04 LTS O/S, the LUN appears to boot since it shows the Ubuntu Grub menu but then drops out to BusyBox with a few errors as below. Any idea what I’m doing wrong here? The steps I took were as follows: (A) Use KVM (proxmox) to map the empty iSCSI LUN as single disk to a VM (UEFI 64 bit) (B) Install Ubuntu 18.04 LTS to the empty LUN © Check Ubuntu is installed to the VM as expected then stop the VM and detach the LUN from the VM. (D) Boot a different VM (with only a simple 1GB disk attached but set to Network Boot) to iPXE and choose the following menu option: Code: :iscsi-boot-ubuntu-18-04-lts (E) iPXE boots the LUN to the Ubuntu "GNU Grub version 2.02" menu and I select “Ubuntu” to start Ubuntu (F) After a minute or so, the following errors are shown in the terminal and I'm dropped to a BusyBox (initramfs) prompt: Code: WARNING: Failed to connect to lvmetad. Falling back to device scanning. Thanks! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
iPXE boot Ubuntu 18.04 LUN - n1nj4888 - 2019-03-13 04:45
RE: iPXE boot Ubuntu 18.04 LUN - MultimediaMan - 2019-03-13, 17:45
RE: iPXE boot Ubuntu 18.04 LUN - n1nj4888 - 2019-03-14, 01:45
RE: iPXE boot Ubuntu 18.04 LUN - MultimediaMan - 2019-03-14, 16:26
RE: iPXE boot Ubuntu 18.04 LUN - n1nj4888 - 2019-03-20, 11:44
|
User(s) browsing this thread: 1 Guest(s)