Sanboot Win7/8/10 after cloning disk on same Hardware

[NiKiZe]

Inaccessible bootdevice, the 0x7b error ....

Did you install the NIC in the image before trying to boot it?

The NIC needs to be installed into the image, if not then there is no way for the Windows kernel to find your disk once BIOS calls goes out of scope.
The NIC needs to be set to boot-critical for it to be loaded and started early in the boot process so the disk can be found and boot continued.

There should be several guides on this already,
But searching now and I find nothing, however here is a post explaining what needs to be done: http://forum.ipxe.org/showthread.php?tid...48#pid6648
Sorry for not being able to find the exact required registry hack right now.