iPXE discussion forum / iPXE user forums / General v / no iSCSI target for win7 install (several examples - none work)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
no iSCSI target for win7 install (several examples - none work)
2013-01-18, 13:36
Post: #2
robinsmidsrod Offline
iPXE forum administrator
*******
 		Posts: 941
Joined: 2011-Apr
Reputation: 15
RE: no iSCSI target for win7 install (several examples - none work)
From what I've gathered from the source code of int13_describe(), the iBFT is reset each time you you perform a sanhook or sanboot command, which only allows the last sanhook/sanboot command to actually be included in the iBFT. If you can manage to only perform one sanhook (for the install drive) and boot PE using e.g. wimboot it is more likely to work.

I also noticed that you set root-path to ${base-iscsi} and not ${base-iscsi}:mytarget. Is that actually correct?
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: no iSCSI target for win7 install (several examples - none work) - robinsmidsrod - 2013-01-18 13:36



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication