iPXE discussion forum / iPXE user forums / General v / Pre-installed Win7 x64 boot to ramdisk via iPXE

Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pre-installed Win7 x64 boot to ramdisk via iPXE
2013-02-17, 21:23
Post: #2
robinsmidsrod Offline
iPXE forum administrator
*******
 		Posts: 941
Joined: 2011-Apr
Reputation: 15
RE: Pre-installed Win7 x64 boot to ramdisk via iPXE
If you want to boot a .wim file, then you're stuck with what will work in a Windows PE environment. If WinPE can't run the software you want it to, then your only choice is to use either iSCSI or AoE on a fully installed system (that is, install Windows to an iSCSI/AoE volume). Be aware that Windows only supports iSCSI out of the box. For AoE you'll need a customized installation.

Are you absolutely sure that you can't get DirectX to work in Windows PE? I would think it could work, but you'll probably have to do a lot of manual work.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Pre-installed Win7 x64 boot to ramdisk via iPXE - robinsmidsrod - 2013-02-17 21:23



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication