Multiple iSCSI Targets

[robinsmidsrod]

Only one iSCSI volume/target can be present in the iBFT. The last one you use in your script will be the one present in the iBFT and should show up in Windows disk manager. I would suggest you use the method in http://ipxe.org/howto/winpe to boot the installer instead of trying to sanboot multiple volumes.

If you have problems with the disk not showing up, even after all this, you might be suffering from the default gateway issue. Try putting set netX/gateway 0.0.0.0 before your sanhook/sanboot command to work around this issue in the Windows iSCSI boot support. Also be aware when you use wimboot to boot WinPE with iSCSI hooked, you'll get two pauses of approx. 1 minute during bootup. We haven't found any way to avoid that yet.