Multiple iSCSI Targets

[dot64]

Thanks for the recommendation. I was successfully able to boot via wimboot to winpe then loaded win7 install from IIS.

After installing Windows, I ran into a few snags which i was able to resolve after a bit of research. One issue i face now is accessing a network share on the server that is hosting the iSCSI that I am booting off of. I cannot access it. I found out via the article below that this is by design.

http://support.microsoft.com/kb/938120

I am using the IP address of the location to connect to the iSCSI during iPXE prior to booting. Although I could setup the shared storage on another system, if its possible I'd like to keep current setup the way it is. Any suggestions on this issue?