[HOWTO] Using QNAP TS-221 as PXE server / iscsi target.

Thread Rating:

1 Vote(s) - 5 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[HOWTO] Using QNAP TS-221 as PXE server / iscsi target.

2013-09-09, 12:36

Post: #2

robinsmidsrod Offline

iPXE forum administrator

Posts: 941
Joined: 2011-Apr
Reputation: 15

RE: [HOWTO] Using QNAP TS-221 as PXE server / iscsi target.

Good of you to write up how you did it.

Just be aware that the keep-san and skip-san-boot flags are deprecated, and it is considered a better approach to use sanhook and sanboot respectively with a bit of scripting to do what is needed. Use http://ipxe.org/cmd/sanhook when you want to install to the iSCSI volume, and http://ipxe.org/cmd/sanboot when you're ready to boot the iSCSI volume itself.

« Next Oldest | Next Newest »

Messages In This Thread

[HOWTO] Using QNAP TS-221 as PXE server / iscsi target. - jrsmile - 2013-09-06, 12:48

RE: [HOWTO] Using QNAP TS-221 as PXE server / iscsi target. - robinsmidsrod - 2013-09-09 12:36

RE: [HOWTO] Using QNAP TS-221 as PXE server / iscsi target. - jrsmile - 2013-10-08, 15:10

RE: [HOWTO] Using QNAP TS-221 as PXE server / iscsi target. - exzR - 2013-12-15, 19:15

User(s) browsing this thread: 2 Guest(s)