Threaded Mode | Linear Mode

trentster · (This post was last modified: 2013-10-05 14:48 by robinsmidsrod.)

Hi there.

I see you mentioned you got ipxe chainloading to work with pfsense. I am battling with this and wondering if you could share your setup on the pfsense side. Can this be done natively with within the pfsense Ui or did you ahve to serve a script?

Could you paste your config and/or a screenshot of the setting you are using in the pfsense UI to get it to work. I am on latest version of pfsense 2.1

Thanks so much

Mark

(2013-05-20 23:42)nry Wrote: Pulling my hair out with this one a little. As previously I got this up and running in under an hour with little to no hassle.

Setup PXE on pfSense to chainload iPXE with the following command on a script on a webserver...

sanhook --drive 0x91 iscsi:10.0.0.30:::5:iqn.2013-04.home.nas:esxi4
sanboot --no-describe iscsi:10.0.0.30:::1:iqn.2013-04.home.nas:installer

Worked perfectly!