Problem connecting to iSCSI target

[tkircht]

This is probably a stupid newbie problem, but I'm stuck anyway, so perhaps someone can point me to the right direction...

I am trying to mount an iSCSI-volume located on a windows Server (192.168.1.6/HYVE03). I am using an iPXE USB stick I created as per instructions.
I am using a machine that has a disk with windows 7 attached so I tried to acces the volume using MS iSCSI Initiator using the iqn:
iqn.1991-05.com.microsoft:hyve03-lnx-test-target

This way I could connect and use that volume.

Then I started the same machine from the iPXE-USB stick and did:
iPXE> dhcp
DHCP (net0 .......).....ok
iPXE> sanhook iscsi:192.168.1.6:::0:iqn.1991-05.com.microsoft:hyve03-lnx-test-target
Could not open SAN device: No such device (http://....)

I am not using any PAP/CHAP authentication and I am using the IP-address as initiator name in the iSCSI target definition.
I used the config-command to make sure I get proper IP-information. I even tried setting the root path option in dhcp - I get that information on the iPXE client but I still cannot boot.

Any ideas what I am doing wrong here??


Thanks

Thomas