Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem connecting to iSCSI target
2011-10-24, 08:54
Post: #3
RE: sanhook
Are you sure that you have allowed ipxe (with its initiator-iqn) to actually connect to the iSCSI target? First verify that you can connect to it with another client (e.g. Microsoft iSCSI client). Then you need to ensure the target is available for the specific initiator-iqn ipxe sends out. It is org.ipxe.something... I think you can find out the exact one by using the config command in ipxe shell. You can also do a wireshark trace and see the initiator-iqn used in the packet.

If all this fails, you might've found a bug that stops it from working. I'm going to assume that booting normal boot images works as expected?
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
sanhook - dpuckett - 2011-10-20, 03:39
RE: sanhook - robinsmidsrod - 2011-10-24 08:54



User(s) browsing this thread: 1 Guest(s)