Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A basic guide
2018-09-19, 12:45
Post: #2
RE: A basic guide
You need to be more specific about what works and what doesn't

My guess is that your DHCP does not give the correct info for network boot.
Hyper-V is horrible client to debug this, and windows DHCP service is horrible to configure.
If this is the state you are in then I would start doing packet capture with for example wireshark to figure out which information is in the DHCP traffic, and to see if there is any TFTP traffic.

Reading over your notes again I'm currious where you have added ipxe.efi or snponly.efi?
Please see https://2pintsoftware.com/whitepaper-usi...e-booting/ for some good pointers.

Use GitHub Discussions
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
A basic guide - Wildfire3 - 2018-09-19, 09:21
RE: A basic guide - NiKiZe - 2018-09-19 12:45
RE: A basic guide - Wildfire3 - 2018-09-19, 14:49
RE: A basic guide - NiKiZe - 2018-09-19, 15:38
RE: A basic guide - Wildfire3 - 2018-09-20, 14:05
RE: A basic guide - NiKiZe - 2018-09-20, 20:23



User(s) browsing this thread: 1 Guest(s)