iPXE discussion forum / iPXE user forums / General v / Why Esxi 6.5 or 6.7 fail to start setup GUI via iPXE

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Why Esxi 6.5 or 6.7 fail to start setup GUI via iPXE
2020-09-07, 02:46
Post: #28
pxe_curious Offline
iPXE User
**
 		Posts: 34
Joined: 2014-Aug
Reputation: 2
RE: Why Esxi 6.5 or 6.7 fail to start setup GUI via iPXE
My point was not really about snponly.efi vs ipxe.efi.

The thing I noticed was that when I used a signed iPXE binary for UEFI booting, I did not have this issue. No change to iPXE scripts or anything else was required. Just replacing the iPXE.efi file with a signed one did the trick.

It seems that mboot.efi is able to load the modules into memory just fine, but when it tries to hand control over to the actual kernel, things break down - on some hardware, but not all. As I said, I don't have an issue with Dell servers, but with Lenovo I do.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Why Esxi 6.5 or 6.7 fail to start setup GUI via iPXE - pxe_curious - 2020-09-07 02:46



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication