The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 807 - File: showthread.php PHP 7.3.15 (Linux)
File Line Function
/showthread.php 807 errorHandler->error




iPXE discussion forum / iPXE user forums / General v / Using configuration settings in iSCSI boot

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Using configuration settings in iSCSI boot
2013-01-14, 20:32
Post: #1
moneysmith Offline
iPXE User
**
 		Posts: 2
Joined: 2013-Jan
Reputation: 0
Using configuration settings in iSCSI boot
I am trying to write a script that uses the "read" or "dhcp" commands to set configuration settings (such as initiator-iqn) and then uses those settings to iSCSI boot. However, all of the examples of sanboot that I can find have the IP address and iqn hardcoded (e.g. sanboot iscsi:10.0.4.1:::1:iqn.2010-04.org.ipxe.dolphin:storage).

Is there a way to either boot using the configuration that has already been set or to feed configuration settings into sanboot?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Using configuration settings in iSCSI boot - moneysmith - 2013-01-14 20:32



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication