iscsi boot to netapp
|
2013-04-02, 17:25
(This post was last modified: 2013-04-03 17:11 by robinsmidsrod.)
Post: #1
|
|||
|
|||
iscsi boot to netapp
I am testing various ways to load RHEL on servers with no internal hard drives on luns we've created on a netapp using 1) open-iscsi capable nics, 2) ipxe, 3) dracut (RHEL6).
I really want to get ipxe to work since it's not hardware or OS dependent. After pouring through the documents and threads it looks like iPXE should be straight forward but I am unable to get it to work properly. I believe that my dhcpd.conf file and the netapp set up properly but I am getting the following error on the client: Could not open SAN device: Input/output error (http://ipxe.org/1d704539) No more network devices On the netapp we get a message that says: ISCSI: New session from initiator iqn.2013-03.com.redhat:test18 at IP addr 10.10.10.2 I have a verified load on lun id 18 within the netapp. Relevant part dhcpd.conf file: Code: allow booting; We know that the target and OS on the lun is good because we can boot to this lun using the NIC's open-iscli's capabilities. Any suggestions on what we could do to troubleshoot would be greatly appreciated. Thanks! -Charlie |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
iscsi boot to netapp - topspincharlie - 2013-04-02 17:25
RE: iscsi boot to netapp - robinsmidsrod - 2013-04-03, 17:15
RE: iscsi boot to netapp - topspincharlie - 2013-04-03, 19:37
RE: iscsi boot to netapp - robinsmidsrod - 2013-04-03, 21:58
RE: iscsi boot to netapp - topspincharlie - 2013-04-04, 16:36
RE: iscsi boot to netapp - robinsmidsrod - 2013-04-05, 10:49
RE: iscsi boot to netapp - robinsmidsrod - 2013-04-05, 10:54
RE: iscsi boot to netapp - ArneLovius - 2013-04-05, 23:46
RE: iscsi boot to netapp - MultimediaMan - 2013-04-06, 21:07
|
User(s) browsing this thread: 1 Guest(s)