Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Multiple iSCSI Targets
2013-06-07, 14:03
Post: #3
RE: Multiple iSCSI Targets
Thanks for the recommendation. I was successfully able to boot via wimboot to winpe then loaded win7 install from IIS.

After installing Windows, I ran into a few snags which i was able to resolve after a bit of research. One issue i face now is accessing a network share on the server that is hosting the iSCSI that I am booting off of. I cannot access it. I found out via the article below that this is by design.

http://support.microsoft.com/kb/938120

I am using the IP address of the location to connect to the iSCSI during iPXE prior to booting. Although I could setup the shared storage on another system, if its possible I'd like to keep current setup the way it is. Any suggestions on this issue?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Multiple iSCSI Targets - dot64 - 2013-06-03, 22:42
RE: Multiple iSCSI Targets - dot64 - 2013-06-07 14:03



User(s) browsing this thread: 1 Guest(s)