Replace the existing PXE ROM on BCM5708 network card

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

Replace the existing PXE ROM on BCM5708 network card

2013-06-26, 09:14

Post: #3

CGen

iPXE User

Posts: 10
Joined: 2013-May
Reputation: 0

RE: Replace the existing PXE ROM on BCM5708 network card

Hi!

This is a separate network card from IBM. I use it to experiment with iPXE.
For experiments using a conventional PC.
OK let bnx2 is not very good. It is not important.
iPXE shows no signs of PXE, ie no messages, etc.
Or should I try on Intel?

I'm just interested in the mechanism boot a computer without TFTP. Only by means of a network card.

Thanks!

« Next Oldest | Next Newest »

Messages In This Thread

Replace the existing PXE ROM on BCM5708 network card - CGen - 2013-06-25, 01:08

RE: Replace the existing PXE ROM on BCM5708 network card - robinsmidsrod - 2013-06-25, 13:11

RE: Replace the existing PXE ROM on BCM5708 network card - CGen - 2013-06-26 09:14

RE: Replace the existing PXE ROM on BCM5708 network card - robinsmidsrod - 2013-06-27, 13:19

RE: Replace the existing PXE ROM on BCM5708 network card - CGen - 2013-06-27, 16:10

User(s) browsing this thread: 1 Guest(s)