iPXE discussion forum / iPXE user forums / General v / ESXi 5.5 Install (via iPXE using Razor) - Failed to free base memory

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ESXi 5.5 Install (via iPXE using Razor) - Failed to free base memory
2014-08-16, 20:41
Post: #5
MultimediaMan Offline
iPXE Fan
***
 		Posts: 200
Joined: 2011-May
Reputation: 8
RE: ESXi 5.5 Install (via iPXE using Razor) - Failed to free base memory
(2014-08-11 14:14)onxis Wrote:  For anyone following this thread, this appears to be a known issue with PXE if a larger than 1500 byte frames are received?

http://www.linuxquestions.org/questions/...xe-623714/

... tends to suggest a PXE issues vs ESXi installer issue. That seems odd since 9k frames if supported by the network, should be enabled by default... and for NexentaStor, its a per VIP setting. I don't want to setup a new VIP in NexentaStor for serving boot volumes and associating a new pool just for this use case.

You're probably looking at a Hardware-Level or UNDI stack limitation. I have jumbo frames enabled on my network, and in use, and don't get these errors. Are you doing Boot from SAN or something else?
"Thus far, you have been adrift within the sheltered harbor of my patience..."
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ESXi 5.5 Install (via iPXE using Razor) - Failed to free base memory - MultimediaMan - 2014-08-16 20:41



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication