Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Installing Win7 to an iSCSI target
2014-08-31, 10:06
Post: #2
RE: Installing Win7 to an iSCSI target
The only thing I can think of is that you're hitting the problem because you're using exit and installing from local media. I would suggest you try to boot up your WinPE environment using wimboot, as explained here: http://ipxe.org/howto/winpe

That might make your iSCSI device hooked the proper way. The gateway "hack" is required if you don't have a router which is routing packets back to your local network properly, or if you need to avoid e.g. 10/100Mbit ports on your router, which would be slow if you're doing gigabit elsewhere.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Installing Win7 to an iSCSI target - robinsmidsrod - 2014-08-31 10:06



User(s) browsing this thread: 1 Guest(s)