Search
Member List
Calendar
Help
iPXE discussion forum
/
iPXE user forums
/
General 
/
iPXE cannot do dhcp with: Could not configure net0
/
iPXE cannot do dhcp with: Could not configure net0
|
iPXE cannot do dhcp with: Could not configure net0
|
|
2014-10-22, 17:07
Post: #2
|
|||
|
|||
|
RE: iPXE cannot do dhcp with: Could not configure net0
I have seen issues with DHCP timing out on both the initial DHCP request as well as with the 2nd request, which you appear to be describing. In both cases I have found that more often than not this is an issue relating to Spanning Tree (http://en.wikipedia.org/wiki/Spanning_Tree_Protocol). Try turning off STP on the port that the machine is connected to. You can enable PortFast if your device supports that feature, which will have the same effect.
|
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
iPXE cannot do dhcp with: Could not configure net0 - naruto - 2014-10-13, 13:19
RE: iPXE cannot do dhcp with: Could not configure net0 - isi_spike - 2014-10-22 17:07
RE: iPXE cannot do dhcp with: Could not configure net0 - robinsmidsrod - 2014-12-03, 15:21
RE: iPXE cannot do dhcp with: Could not configure net0 - infocuspix - 2016-03-04, 23:42
|
User(s) browsing this thread: 1 Guest(s)