iPXE discussion forum / iPXE user forums / General v / Attaching more than 1 san target

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Attaching more than 1 san target
2014-12-03, 16:42
Post: #2
robinsmidsrod Offline
iPXE forum administrator
*******
 		Posts: 941
Joined: 2011-Apr
Reputation: 15
RE: Attaching more than 1 san target
As mentioned in the response to the other thread you referenced, you can have only one volume described at boot. I'm not sure why, but you could try to disable the removal of other volumes and see how it works. Check the int13_describe() function in the source for the line to disable and recompile. Please do tell how it works out for you.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Attaching more than 1 san target - robinsmidsrod - 2014-12-03 16:42



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication