iPXE EFI - no network after the DHCP sequence

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

iPXE EFI - no network after the DHCP sequence

2016-12-16, 21:43

Post: #5

methodmath Offline

iPXE User

Posts: 1
Joined: 2016-Dec
Reputation: 0

RE: iPXE EFI - no network after the DHCP sequence

hi,

we had a similar problem. The solution was to enable portfast on the port where our servers were connected.

we lost a lot of time on that. I suspect the root cause is the intel driver for i350 but enabling portfast in the switch was the easy fix after a few days of debugging...

« Next Oldest | Next Newest »

Messages In This Thread

iPXE EFI - no network after the DHCP sequence - cbn38 - 2016-09-12, 17:21

RE: iPXE EFI - no network after the DHCP sequence - NiKiZe - 2016-09-13, 20:03

RE: iPXE EFI - no network after the DHCP sequence - cbn38 - 2016-09-14, 16:34

RE: iPXE EFI - no network after the DHCP sequence - cbn38 - 2016-09-16, 17:31

RE: iPXE EFI - no network after the DHCP sequence - methodmath - 2016-12-16 21:43

RE: iPXE EFI - no network after the DHCP sequence - NiKiZe - 2016-12-17, 11:04

User(s) browsing this thread: 1 Guest(s)