Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
iSCSI ipxe.pxe/sanboot error 1d704098
2020-05-15, 23:48
Post: #1
iSCSI ipxe.pxe/sanboot error 1d704098
I have a Windows 2016 configured as iSCSI Target... Angel

I connect OK to the iSCSI drives from other machines in the LAN
with the Microsoft iSCSI client (iscsicpl.exe) Cool

When I try to connect via ipxe.efi/sanboot it gaves me this error:
"Could not open SAN device: Input/output error (http://ipxe.org/1d704098)" Dodgy

consulting the suggested URL:
---
Possible sources
This error originated from one of the following locations
within the iPXE source code:
drivers/block/scsi.c (line 494)
---

the ipxe script lines for the iscsi config/invoke are:
---
set initiator-iqn iqn.1991-05.com.microsoft:server1
sanboot iscsi:10.0.0.1:tcp:3260:0:iqn.1991-05.com.microsoft:disk1 ||
---

PS:
* 10.0.0.1 is the NIC I have on server1 for iSCSI service
* as I said... it connects OK with the Windows iSCSI client

I downloaded the last ipxe.efi binary from "http://boot.ipxe.org"
and try other 2 older binaries with the same result...

?does anyone have any ideas where to look?? HuhAngry
Find all posts by this user
Quote this message in a reply
2020-05-18, 17:16 (This post was last modified: 2020-05-18 18:20 by IBIT.ZEE.)
Post: #2
RE: iSCSI ipxe.pxe/sanboot error 1d704098
Well--- as "always"... it is a somewhat stupid thing... Undecided

I was assuming that the first-and-only disk I have set in the Server (Target) was LUN0...

and I was using the simple iSCSI URI: Angel

iscsi:server1::::iqn.1991-05.com.microsoft:disk1

as "always"... there are Microsoft things that only Micro$oft '''understand''': Angry
the target disk (the only one in the system) was beeing set as LUN1???

as I can't see this information in the Windows Server Target
only with a diagnostic tool i could find that LUN1 (and not LUN0)
was being set by the iSCSI Server

Sooooo...

iscsi:server1:::1:iqn.1991-05.com.microsoft:disk1

works fine... Cool
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)