Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Unregistered SAN device
2012-05-04, 10:40
Post: #1
Unregistered SAN device
Hello,

I tried to set up iPXE to my iSCSI target on which I plan to install Windows 7 but it seems like I have some troubles:

[Image: 28b8bpj.jpg]


There is an Unregistered SAN Device error.

When I do same settings for gPXE then everything is working fine, only iPXE have troubles. Any one have some ideas?
Find all posts by this user
Quote this message in a reply
2012-05-07, 10:12
Post: #2
RE: Unregistered SAN device
As the error page, http://ipxe.org/2e852001 , tells you (look at the bottom), "This error usually indicates that the SAN disk is empty, and does not yet contain a bootable operating system."

You need to use the sanhook command, http://ipxe.org/cmd/sanhook , to "hook" the iSCSI target as a local BIOS drive, and THEN start the installer. This can be done in a multiple different ways, and depending on your BIOS, different solutions offer different challenges. You can try to just exit from iPXE and boot the Windows 7 installer from DVD, you could boot WinPE and start the installer from it, https://gist.github.com/2234639#L280 , or you could use Microsoft WDS (Windows Deployment Services), as shown here: http://ipxe.org/howto/wds_iscsi
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)