The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 807 - File: showthread.php PHP 7.3.15 (Linux)
File Line Function
/showthread.php 807 errorHandler->error




iPXE discussion forum / iPXE user forums / General v / wimboot and Hyper-V

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wimboot and Hyper-V
2012-11-01, 02:33 (This post was last modified: 2012-11-01 02:34 by MultimediaMan.)
Post: #1
MultimediaMan Offline
iPXE Fan
***
 		Posts: 200
Joined: 2011-May
Reputation: 8
wimboot and Hyper-V
Hello again!

Observed on a Hyper-V server:

Guest VM with a Legacy (PXE enabled) NIC:

iPXE Loads, and will deliver a wide variety of images (CentOS, RedHat, SUSE 11) without issue.

But when using wimboot, v0.9x-v1.0, when the wimboot wim image load finishes, the guest crashes immediately and reboots.

Using wimboot v1.01-1.02 the wim image load completes, but gets stuck at a blinking cursor.

VMware-based guests served from the same iPXE TFTP and Webservers do not exhibit this issue and go on to boot the wim successfully.

Thoughts or ideas for troubleshooting?

Best,

Matt
"Thus far, you have been adrift within the sheltered harbor of my patience..."
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
wimboot and Hyper-V - MultimediaMan - 2012-11-01 02:33



User(s) browsing this thread: 1 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication