iPXE fails to boot anything

[AyrA]

(2013-02-19 10:59)robinsmidsrod Wrote:  You need to move the kernel command line parameter "iso" onto the "kernel" line instead of the "initrd" line

Done, but it didn't get any farther

(2013-02-19 10:59)robinsmidsrod Wrote:  you might want a "|| goto failed" at the end of the "choose" command.

Done

(2013-02-19 10:59)robinsmidsrod Wrote:  ...tested with memtest and breakin? Does it come out clean?

memtest comes out ok with all tested Versions, the other software I have never heard of. If you can provide a link to it I will test it too.
Memtest seemed to boot just fine, might be because it is a floppy image rather than an ISO Image

(2013-02-19 10:59)robinsmidsrod Wrote:  You might also try just "sanboot http://192.168.252.1/PXE/iso/atih11.iso" instead of using memdisk and see how that works instead.

It definitely gets farther ahead and it also boots instantly, but no matter what iso I boot (and they all work over regular pxe or if booted with syslinux from a usb drive) at some point in the boot sequence it stops, I assume that the OS from the image sort of "drops the handle" to the iPXE sanboot layer.

(2013-02-19 10:59)robinsmidsrod Wrote:  you might have better luck with ipxe.pxe (which uses iPXE-provided drivers for the hardware in question instead of vendor-provided drivers).

I tried it but the result is the same.