Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Multiple iSCSI Targets
2013-06-05, 09:42
Post: #2
RE: Multiple iSCSI Targets
Only one iSCSI volume/target can be present in the iBFT. The last one you use in your script will be the one present in the iBFT and should show up in Windows disk manager. I would suggest you use the method in http://ipxe.org/howto/winpe to boot the installer instead of trying to sanboot multiple volumes.

If you have problems with the disk not showing up, even after all this, you might be suffering from the default gateway issue. Try putting set netX/gateway 0.0.0.0 before your sanhook/sanboot command to work around this issue in the Windows iSCSI boot support. Also be aware when you use wimboot to boot WinPE with iSCSI hooked, you'll get two pauses of approx. 1 minute during bootup. We haven't found any way to avoid that yet.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Multiple iSCSI Targets - dot64 - 2013-06-03, 22:42
RE: Multiple iSCSI Targets - robinsmidsrod - 2013-06-05 09:42
RE: Multiple iSCSI Targets - dot64 - 2013-06-07, 14:03



User(s) browsing this thread: 1 Guest(s)