Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can't figure out to to boot to my SCCM Server
2017-01-27, 16:04
Post: #9
RE: Can't figure out to to boot to my SCCM Server
(2017-01-27 02:15)NiKiZe Wrote:  
(2017-01-26 16:57)Br1lliantJim Wrote:  Thanks! My main concern is that 10.0.2.4 isn't my SCCM server. In fact, I'm not sure what that even is. Both the client and the server can ping it, but my server's address is 10.0.2.15, which the client receives DHCP from.

So in the end, I have no clue what Test.pxe is or where it is coming from.

My guess is that it is the hosting environments dhcp server, it might just respond to bootp requests which prevents you from seeing responses from that DHCP server in other dhcp clients. Are you sure the 2.4 IP isn't the host itself via a vbox IP?

How is iPXE loaded ? (based on the features i guess it is embeded ipxe isarom for virtualbox)
Since that rom is quite limited in size it might be hard to enable debug options, but you could always try to build with DEBUG=dhcp
otherwise test pressing ctrl-b to get iPXE shell, then run dhcp followed by config and let's hope it gets you more information about the configuration, or atleast you should be able to use that way to then load another ipxe binary with dhcp debugging enabled.
I boot from an iPXE disk I made. Oddly enough, when I changed my server's address to 2.25, my client still references 2.15. I'm beginning to think they aren't actually connected at all.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Can't figure out to to boot to my SCCM Server - Br1lliantJim - 2017-01-27 16:04



User(s) browsing this thread: 1 Guest(s)