Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
dnsmasq incompatibility?
2013-07-11, 10:48
Post: #1
dnsmasq incompatibility?
Hi!

I am trying to netboot a laptop that has no builtin PXE support.
I tried gPXE 1.0.1 and iPXE 1.0.0+ (9361).

After getting IP config over DHCP, gPXE prints:
No filename or root path specified
No more network devices

iPXE prints a similar message:
Nothing to boot , http://ipxe.org/2d03e13b

Apparently filename and root-path are empty (checked as described on the error page).

The cause might be some incompatibility between iPXE and dnsmasq as described here: http://etherboot.org/wiki/dnsmasq#a_pote..._and_a_fix

Other PCs with builtin PXE support work fine on the same LAN.

Any idea how to proceed troubleshooting? Use a debug build?
Find all posts by this user
Quote this message in a reply
2013-07-17, 14:54 (This post was last modified: 2013-07-20 17:09 by robinsmidsrod.)
Post: #2
RE: dnsmasq incompatibility?
I would suggest you use the most recent build, which you can also build using http://rom-o-matic.eu/ and use DEBUG=autoboot, maybe this will shed some light on what's going on. Obviously you should just boot into iPXE using the normal chainloading, run dhcp followed by config and verify that the next-server and filename params are there. If they are not, then you need to look more carefully at your dnsmasq configuration.
Visit this user's website Find all posts by this user
Quote this message in a reply
2013-07-18, 10:54
Post: #3
RE: dnsmasq incompatibility?
Thanks, I selected the ISO format on rom-o-matic, debug: autoboot and revision: master

Then run it (defaults with no user input) on the laptop and it loads the network boot stuff correctly. Therefore I did not pay much attention to the debug output.

If anyone is interested, I can throw a second look to the details.
Find all posts by this user
Quote this message in a reply
2013-07-18, 21:27 (This post was last modified: 2013-07-18 21:27 by xerces8.)
Post: #4
RE: dnsmasq incompatibility?
Actually, I tried again the "older" versions and now they work too.
Either the boot server was having hiccups or maybe I accidentally connected the laptop to the wrong ethernet segment.
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)