The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 807 - File: showthread.php PHP 7.3.15 (Linux)
File Line Function
/showthread.php 807 errorHandler->error




iPXE discussion forum / iPXE user forums / General v / ipxe failover to USB not working

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ipxe failover to USB not working
2014-11-10, 17:12 (This post was last modified: 2014-11-23 19:25 by mikechan.)
Post: #1
mikechan Offline
iPXE User
**
 		Posts: 2
Joined: 2014-Nov
Reputation: 0
ipxe failover to USB not working
Hi,
I made a USB stick of Windows 7 Pro. I am using ASUS B85-PLUS motherboard. It is OK to boot the USB as the first booting device both SATA or EFI. It is OK to failover to boot the DVD as the second booting device when I boot from IPXE blank iscsi volume. But when I set up the USB as the second booting device and hoping to failover to the USB, I am failed. Some please help me. I need boot from USB instead of DVD.
It is OK to failover to DVD but I cannot find any iscsc drives and I clearly saw the message says target has been registered.
Then I was trying to load the network card driver, I failed again. There is no hope to install Windows 7 on a iscsi target via IPXE for ASUS B85-PLUS motherboard.

Seems the same problem as http://forum.ipxe.org/showthread.php?tid=7356

Thanks!

Mike
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ipxe failover to USB not working - mikechan - 2014-11-10 17:12



User(s) browsing this thread: 2 Guest(s)

Contact Us | iPXE home page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication